Our range of backflow prevention devices are manufactured in our WA factory and approved to AS/NZS 2845.1. Constructed from dezincification resistant (DR) brass the units consist of two independently acting internally loaded check valves. With a low hazard rating the units perform to a maximum temperature of 60 degrees celsius and a maximum pressure of 1200kPa. All units can be installed vertically or horizontally however they must not be subject to flooding or freezing.
The mini dual check valves are primarily designed to provide protection from potential contamination to the potable water supply in low hazard applications for individual fixtures.
These valves are best suited for exposed installations, under sinks and vanity units.
All Galvin Engineering products are WaterMark certified and compliant to all relevant Australian standards.
Features
Technical Information
We are ISO 14001 certified and take sustainability seriously. Our products are environmentally responsible designed to be healthier for users, save water and/or energy, and minimise carbon footprint. Our target is to reduce our carbon footprint by 25%, and the use of non-recyclable/non-compostable materials across the company (e.g. plastics) by 50%.
Galvin Engineering products are covered under our Manufacturer's Warranty. Galvin Engineering products must be installed in accordance with the installation instructions and in accordance with AS 3500 and NCC Volume Three, relevant Australian Standards and local authorities applicable to product being installed. Water and electrical supply conditions must also comply to the applicable national and/or state standards, failing to comply with these provisions may void the product warranty and affect performance of the product.
Please visit www.galvinengineering.com.au to view the full warranty, our Installation Compliance and Maintenance & Cleaning information as well as any other additional information.
While all reasonable care has been taken in compiling the information in this document, the designs, dimensions and products shown are indicative only and should not be relied upon without our prior approval. Due to our policy of continuous development, we reserve the right to alter any details of specifications or products without notice. All information, drawings, technical specifications and product designs remain the property of Galvin Engineering Pty Ltd.
Click the buttons below to read Galvin Engineering's Terms and Conditions.
 |
 |
 |
